Dust Cover Z Axis X1C P1P
Copyright Claim
Dust Cover Z Axis X1C P1P
Boost
160
333
62
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
22 min
1 plate
0.2mm nozzle, 0.1mm layer, 4 walls, 15% infill
48 min
1 plate
Boost
160
333
62
1
750
334
Released
Description
This is a simply Dust Cover Z Axis
Comment & Rating (62)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
funktioniert, aber geht besser :)
The designer has replied
0
Reply
Friend, be careful that you have to lower the rubber or remove it, don't blame the design
0
Reply
In your opinion, how can this one I have in my x1 be perfect? Magic?
0
Reply
Good design. Fits perfectly.
The designer has replied
1
Reply
Thank you very much for your feedback
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 15% infill
perfect
(Edited)
The designer has replied
1
Reply
Thank you very much for your feedback
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
good profile, fits good.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
The designer has replied
1
Reply
Thank you very much for your feedback
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Doesn't snap in but great print
The designer has replied
1
Reply
It doesn't have to be hooked up, you just have to place it down. Thank you
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Printed well. They don't snap in or anything. Just sit on top of the Z-axis screws. So far they haven't fallen out or anything so, thanks!
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Past perfekt
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld