WARNING, this is a hard project but very rewarding when completed. 9 Plates total. Print 6 background plates in grayscale and glue onto a black posterboard, then print red plate, teal jacket, words and glue onto the background. I actually prefer the colors to stick off above the background for an even better depth.

***Does not fit perfectly, trimming of the colored pieces is necessary if you want them to fit together flush**

Print ALL plates at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Grayscale Background (6 plates) :

Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Steel Grey
At layer #11 (0.96mm) swap to Grey
At layer #16 (1.36mm) swap to White for the rest.

Red Cross (1 plate):

Swap Instructions:
Start with Black
At layer #4 (0.4mm) swap to Red
At layer #9 (0.8mm) swap to Steel Grey
At layer #14 (1.2mm) swap to Ash Gray
At layer #19 (1.6mm) swap to White for the rest.

Teal Jacket (1 plate):

Swap Instructions:
Start with Black
At layer #5 (0.48mm) swap to Green
At layer #9 (0.8mm) swap to Grass Green
At layer #11 (0.96mm) swap to Aqua Blue
At layer #16 (1.36mm) swap to Jade White for the rest.

TRAUMA TEAM words (1 plate):

Swap Instructions:
Start with Black
At layer #3 (0.32mm) swap to Red
At layer #10 (0.88mm) swap to Aqua Blue
At layer #15 (1.28mm) swap to Grey
At layer #19 (1.6mm) swap to White for the rest.