A1 and A1 Mini Cutter Arm Decoration insert Filament
Copyright Claim
A1 and A1 Mini Cutter Arm Decoration insert Filament
Boost
10
18
11
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
36 min
1 plate
Boost
10
18
11
0
37
21
Released
Description
Decorative insert for the cutting arm for the A1 and mini.
Print the first layer slowly, for a good first layer (not like in the picture :-D).
A few raw models as a download for your own design, if you need other formats let me know!
When uploading with your own motifs, please remix, thank you!
Print time, about 29 min
Overall print time 35 min
Comment & Rating (11)
All
I had to reduce mine down to 95% and shave a little bit of with a razor knife. so 93% or 94% may be better. I know 90% is too small.
The designer has replied
0
Reply
hey, did you print this with my profile or own settings? normally it is a soft press fit. so no/low pressure needed to put it on its place
0
Reply
Replying to @tronicpixel
I Can't confirm or deny. I am new to this bambu stuff. So I don't remember what profile I used exactly
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Nice idea !
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
sehr schön gearbeitet 👍🏻volle Punktzahl
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
very nice
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld