Small & Simple Minimalistic Drawer Knob/Pull
Copyright Claim
Small & Simple Minimalistic Drawer Knob/Pull
Boost
14
41
18
Print Profile(1)
0.2mm layer, 4 walls, 25% infill
Designer
16 min
1 plate
Boost
14
41
18
0
135
116
Released
Description
This is a very simple drawer knob/pull.
Very small & minimalistic. It measures just 25mm⌀ x 18mm
prints very quick and only uses 3.6g (1.2m) of filament.
features a hole slightly smaller than 3mm allowing an M3 Bolt to cut it's own thread and holds very well.
Comment & Rating (18)
All
Would you change the license to anything that allows remixes? I know this is pretty simple, but it was the first one I found searching, and I'd like to incorporate it into another model if you'll let me.
The designer has replied
0
Reply
Hi, sure. I have just updated it. It should have been that in the first place, I must have just clicked the wrong one. Hope you can remix it for your own needs.
0
Reply
Replying to @Harley3D
Your updated license still does not allow anyone to distribute remixes. (You need to remove the "NoDerivatives" to allow distribution of modifications.) Because of your comment, I've tentatively posted https://makerworld.com/en/models/148020#profileId-165246 so you can see my remix.
0
Reply
Replying to @usr_29A
very sorry about that. I've just changed it. hope this helps and look forward to seeing your remix.
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
good
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld