Death Star Clock by Nils Kal

Nils Kal

Art>Other Art Models

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.25mm layer, 2 walls, 15% infill

Designer

6 h

2 plates

4.7(19)

0.2mm layer, 2 walls, 15% infill

7.5 h

2 plates

4.7(10)

Boost

140

220

374

294

Released

Description

A long time ago, in a galaxy far far away….

I designed this Star Wars themed clock, the Death Star Clock.

The clock is easy to print and will fit on Mk3 print beds. I've also added a version for the mini, couldn't test this though as I don't own a mini.

The clock itself comes a single piece, you will need supports around the center hole. There are optional minute and hour hands.

A 9mm center hole it has, a clock mechanism like this or similar, you will need.

As a bonus, there's also an X Wing model you can clip on the second indicator, however this may not work with every clock mechanism (depends on the torque of the mechnism). you can clip it under from below.

May try “OPT_X Wing_light.stl" if it doesn't work for your mechanism.

This design is still subject to change so check back again for updates.

If there's demand, I could also upload a version with the non destroyed death star.

May the force be with you!

This work is licensed under the 'Creative Commons NonCommercial' license. Please do not sell any physical or digital copies of it.

Comment & Rating (38)

@DennisV

Very nice, easy to print and works great.

(Edited)

@TomTheBomb

Hello ... Do you have a link to the clock base you used please.

@RandyA

Yes, I see that you need a 9mm hole but what clock mech shaft length is needed?

@mikecoscia

What clock mech did you use? I tried several but none were stong enough to move the x-wing.

@CryptoVice

Great print. Turned out excellent!

@user_1370721339

Print Profile

0.2mm layer, 2 walls, 15% infill

wunderschön 😍

@user_2622157572

Print Profile

0.25mm layer, 2 walls, 15% infill

awesome file. scaled up. green hands to match death Star ray

@user_2622157572

great file. Thanks! printed in silver then washed it in thinned black acrylic/water mix. printed the hands in death star ray green! ;) Made some Tie fighters patrolling the area.

@Riptus

Print Profile

0.25mm layer, 2 walls, 15% infill

it looks great! only complaint is how solid the back is, I wonder if it could be adjusted so that it’s not a solid piece so it would use less filament

@TomTheBomb

Print Profile

0.25mm layer, 2 walls, 15% infill

Order the clock mechanism from Amazon. Need the extra long shaft, or you will have to shorten the depth of the hour hand to make it fit. But awesome build.

(Edited)

@mizace13

Print Profile

0.2mm layer, 2 walls, 15% infill

I'm giving 4 stars only because the link to the clock mechanism doesn't work, and the creator hasn't updated it can't reply to comments with an updated link. I bought a high torque clock mechanism and I still couldn't get it to work with the x wing, so I had to slice the x wing down to about 3 layers for the clock mechanism to work right. also, I had to buy separate clock hands, because I couldn't figure out which click mechanism was used that would support the printer hands in the profile.