No Print Profile yet. Add one to earn points.
I can't believe nobody has made this yet. In an effort to go 2.5Gbe, I bought an MR46 used on eBay for about $270 (Dec 2023). Price was low due to not having a ceiling bracket.
Problem solved.
EDIT: Don't print in PLA. Fell off my ceiling within 24 hours. xD Re-printed in PETG, made a slight modification in V2 so the clip is always under pressure. Problem solved. Again.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
.2
Infill:
20%
Filament:COEX PLA White
Notes:
I'd probably recommend PETG instead of PLA, since the warmth of this device will likely weaken the grab over time potentially. (I'm rolling the dice on PLA; My ceiling isn't that tall, and its carpet below so.... eh)
The nubs need supports to be perfect. You might get away without it. It should audibly snap into place. :)