Face for A1 and A1 mini
Copyright Claim
Face for A1 and A1 mini
Boost
184
212
113
Print Profile(3)
0.12mm layer, 2 walls, 100% infill, Funy Face.
Designer
1.2 h
1 plate
Strong top fasteners. 0.12mm layer, 2 walls, 100% infill
Designer
1.2 h
1 plate
0.12mm layer, 2 walls, 100% infill, only 3 colors.
Designer
1 h
1 plate
Boost
184
212
113
2
490
363
Released
Description
| Update! I added a version with strong top fasteners. If you think that standard hooks are too weak and may break, print a version with reinforced fasteners. You will see details in the photos below. |
A funny face on the front of the extruder that rolls one eye while printing.
Let me know if the print was successful and if everything fits. If any corrections need to be made, let me know.
If you have printed it, please leave a rating.
Before installation, the original front and the rotating element must be dismantled.
During installation, the eye should be pressed as far as it will go. After putting the face, the eye should be flush with the face or deeper.
When assembling, make sure that the top latches are flush with the top edge before pressing from the front.
Assembly instructions below.
Version with strong top fasteners.
Comment & Rating (113)
All
Not sure why the left side of the mouth is doing this. No matter how I orient it on the bed some of it is missing. After slicing it looks fine but Im traying to paint it and Im not able because of this.
The designer has replied
0
Reply
This is a remix of my project and I don't know how it was done. In my case, everything is done on objects and such situations cannot occur. Please direct this question to the author of the remix: https://makerworld.com/it/models/110337#profileId-117930
1
Reply
worked it out. thank you!
0
Reply
Boosted
Used a couple of googly-eyes on top of the existing design to make the face more dynamic. Great file!
2
Reply
perfect ! thank you ! just a small problem: the 2 fasteners at the top broke when i install it.
The designer has replied
0
Reply
Do you want to make a version with reinforced fasteners or was it just an accident?
0
Reply
Replying to @WojciechKawa
yes i think renforce it à little bit Will be better , because i dont force alot on it when it break :( . your work is perfect without this problem ;)
0
Reply
Print Profile
0.12mm layer, 2 walls, 100% infill, Funy Face.
Love it. Snapped on smooth. Eye has plenty of space to turn and popped on snugly.
0
Reply
I haven’t printed anything yet to see if the eye turns.
0
Reply
Great. fun idea.
1
Reply
Print Profile
0.12mm layer, 2 walls, 100% infill, Funy Face.
Printed just fine. adds a bit of whimsy. Thank you!
1
Reply
Thank you so much for your design. It printed beautifully and looks great.
1
Reply
Print Profile
0.12mm layer, 2 walls, 100% infill, Funy Face.
cool
0
Reply
its fun
0
Reply
Mon fils adoré 😜😜😜
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (9)
Click to see more
Related Models
© 2024 MakerWorld