P1P Internal Camera -

https://www.printables.com/model/578508-p1p-internal-camera

• No supports needed
• Print files as downloaded, they are pre-oriented
• 2 covers available for utilizing SD card
• Base has 2 versions, altering viewing angle slightly down to show more build plate

Note: this does not REPLACE the stock camera and is NOT accessible through the Handy app…. just a simple addition, stand-alone camera with its own app for usage (shown below)

Tore apart a 2k baby monitor I found on Amazon daily deals for $16. USB runs through the opening in the rear, or the gap between rear panels if you have a 2 piece full cover. Press fit into holes in rear of machine next to poop chute.

SD card slot on camera. Retains wifi capabilities; plenty of clearance for all machine functions… bed leveling, filament change & wipe, etc.

camera used - https://a.co/d/2xTwDq4

• print parts
• strip camera -

(STICK A SMALL FLATHEAD SCREWDRIVER OR SOMETHING SIMILAR BETWEEN THE BLACK FRONT COVER OF THE CAMERA, AND THE WHITE SIDE HOUSING OF THE CAMERA - IT POPS APART EASY)

• remove housing (camera board is screwed to the white housing) and unplug all items from board minus “IR cut”
• Using a pair of pliers, remove the plastic connector for speaker (“SPK”) This is REQUIRED for proper fit. this will NOT affect anything - shown below

• simply set camera into base, USB port downwards & slide on cover
• press into holes in rear of the printer, plug in.