poignée de porte Alice
poignée de porte Alice
Boost
77
94
9
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
3.5 h
1 plate
Boost
77
94
9
0
80
23
Released
Description
Pour la porte de chambre ou pour celle du petit château… Bref, de la déco ;)
Pour l'intérieur le PLA fera l'affaire; en extérieur utiliser un filament adapté ;)
PETG, ASA, ABS…
Comment & Rating (9)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
printed grate on my A1 had some loose filament trouble under the knob like it might have needed some support there I had to do a lot of sanding but it not visable and it looks grate other then that
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
perfect little decoration for the kids room.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Added a stick home magnet backing. Looked awesome on the door of our Disney cruise ship.
present in copper colored filament.
Noticed a small hole artifact on the side not enough to detract attention. Still a great piece.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Super Datei leider hab ich es nicht hinbekommen das der Knauf ohne Rillen gedruckt wird
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
print had a spaghetti failure. Don't think it was the model because it printed fine the 2nd time. Bambu won't let me rate any higher than 3 stars 😢
0
Reply
very beautyfull
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld