Hello there,

I propose you this useful Broom stick holder that can be mounted on wall / Furniture

This improve system avoid clip that can damage the support and do a satisfying Clic

This model is for 22mm diameter Broom stick, Also give STL for 25mm,30mm,35mm same profil should work fine

No support needed, can be print in PLA (will add my profil BBL Studio for strong part) or others your into.

If you don't use the profile be sure to put a least 4 walls loops and 15% infill to be strong enough

Usage :

1 - Print it

1bis - verify that the print is strong enough

1ter - you can add EPDM tape inside the ring to smoth things up! very easy and removable

2 - put it in a wall with adequate fixation in fonction of your wall

3 - unclip the mechanism

4 - Clip you tube

Et Voila !

you can print more and put it at different places for conviniences

Will upload a model For Dyson Tube look at my profil!

And yes i will do on for light Sabers ;)

OG @fns720

Don't hesitate to like and add to you collection then leave a review after your print it ;)