Hex Spool for Drill Chuck Filament Winder (Remix)
Remixed by
Copyright Claim
Hex Spool for Drill Chuck Filament Winder (Remix)
Remixed by
Boost
20
44
19
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
Boost
20
44
19
0
138
101
Released
Description
This is a REMIX of https://www.printables.com/de/model/378834-hex-spool-for-drill-chuck-filament-winder
I only designed a recess in the hex spool for a 17mm nut.
What you additionally need:
- 2x M10 nut (17 mm outside)
- 1x M10 threaded rod about 12 to 15 cm long (mine is a bit too long at over 20 cm, but still works)
Comment & Rating (19)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
2nd great print
(Edited)
0
Reply
Make in PETG Ecosmart by Printologist
Respooling PETG Devil Design Grey
0
Reply
This equipment really works
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Low time and material consumption, and very usefull. Thanks
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues: Die Überhänge kommen nicht so gut raus...
Ansonsten top Modell.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Super solution, I use it.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fantastico
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Good Job
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
jednoduché funkční
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld