mount for a single hex shaft bit for wall control pegboard systems

bit will fit snug the first time one is insert but will be smoother after a few insertions

this is a centerpiece i made to fit the DDD wall control accessories system made by Allen Dersha his project can be found at https://github.com/aderusha/DDD-Printable-Wall-Control-System and

https://www.printables.com/model/52618-ddd-printable-wall-control-system

the rest of my accessories I've designed for the system can be found here https://makerworld.com/en/u/2234273742/collections/102156

the following parts from Allen's project were used in mounting this model to my pegboard

- 2x1 L Bracket Flat Left

- 2x1 L Bracket Flat Right

- 2x1 Locking Spacer

- 8mm lock pin