★ New ★ Updade ★ from 29.12.2023 Automatic Z-Axis Lube Helper ★ here is the link https://makerworld.com/de/models/112326#profileId-120249

Rod Cleaner Z-Axis Without Logo (simple and short time to print) Single Version

★ New ★ Update ★ Rod Cleaner Set + Tool Case here is the link https://makerworld.com/de/models/99424#profileId-105992

Based on the Carbon Rods Cleaner V2 X-Axis (simple and fast) , I have now designed a Rod Cleaner for the Z-Axis. Again, it's Simple and short time to print.

Of course, there is also a version that is a bit smoother but takes a little longer. This is for those who don't need branding,

and of course,one with a bit of accessories, the Complete Version and with branding

LET'S GET STARTED!

1. Print

2. Take a sponge and cut 2 pieces to the size of 20mm x 30mm, just like with the Carbon Rods Cleaner V2 X-Axis (simple and fast) , and press them into the designated openings. Now soak them with ISO

3. Let's start the cleaning!

Place the small box around the Z-AXIS, hold it with your fingers, and press the desired direction on the display... the cleaning begins :-) Pay attention to the final distance of the Z-Axis Top and Bottom. Do not drive too far, as you could otherwise damage your printer.

Cleaning the rear Z-AXIS is also possible without disassembling the entire printer. For this, I recommend the Rod Cleaner Z-Axis Ultimate Complete Version (what a name).

4. The tweezer for the box with the spacer is very convenient. If you use this combination, you have your fingers free and can easily clean your Z-Axis as shown in the pictures. Of course, it can also be used without a spacer.

4. After you're done, it should look like this :-)

5. After cleaning, you should grease the Z-AXIS again. The included grease in the accessories should be sufficient; if not, purchase new grease.

easy to use, easy to clean

Have fun building and cleaning!

If you like the project, simply like and download it. THX

I also appreciate comments a lot.