Mystery Egg For Minis or Dragons - Easy Print by Raditive Prints

Raditive Prints

Toys & Games>Other Toys & Games

Print Profile(5)

All

P1P

P1S

X1 Carbon

X1E

A1 mini

100% Size 0.2mm layer, 2 walls, 5% infill

Designer

2.8 h

1 plate

4.9(53)

50% Sized 0.2mm layer, 2 walls, 5% infill

Designer

43 min

1 plate

4.9(17)

75% Sized 0.2mm layer, 2 walls, 5% infill

Designer

1.6 h

1 plate

4.8(13)

100, 75 and 50 version to choice in 3 plates - 0.2mm layer, 2 walls, 5% infill

5.7 h

3 plates

5.0(7)

Click to see more

Boost

253

410

1.1 k

1.7 k

Released

Description

Hey!

Here is my adaptation of the mystery eggs. These make for awesome gifts, or to add some spice to your craft booths.

It is a press fit design and the two parts may be hard to press together. If this is the case for you please lower the size of the top by .5%

No support needed

For size comparisons. At 100% it can hole a 75% sized crystal dragon from cinderwing3d

Confirmed by the Cinderwing3D team “so confirmation, 75% egg works with ALL 50% babies 50% egg works with 50% turtles 60% wyverns (all) and various lil Zous”

Comment & Rating (97)

@PiNK_3DP

Print Profile

50% Sized 0.2mm layer, 2 walls, 5% infill

Printed great at 50%. Working on other sizes now!

@sm4lltig3r

Print Profile

50% Sized 0.2mm layer, 2 walls, 5% infill

Cool!

(Edited)

@CheekyHeeler

Print Profile

100% Size 0.2mm layer, 2 walls, 5% infill

Printed these for Christmas gifts. The tiny one is 50% (I think) and fit 2 tiny spiders from Cinderwing3D. The middle one was printed at 100% and fit an 18" gemstone dragon from Cinderwing3D. The giant one was printed at 150% and fit a 100% gemstone baby from Cinderwing3D. The big ones had nice fitting lids and weren't hard to take on and off. The tiny one had issues with the lid being too loose, so I added some scotch tape.

(Edited)

@TheGlockHashira

Print Profile

100% Size 0.2mm layer, 2 walls, 5% infill

Description for certain scale dragons were spot on. Printed to fit a void sea dragon and jellyfish dragon and they fit nicely without the need to cram them in

@NexoPrint3D

Print Profile

100% Size 0.2mm layer, 2 walls, 5% infill

Printed great. thanks

@mwaldegg

Print Profile

100, 75 and 50 version to choice in 3 plates - 0.2mm layer, 2 walls, 5% infill

Had some blobbing - but maybe my filament was wet

@WilderThenBefor

Print Profile

100% Size 0.2mm layer, 2 walls, 5% infill

The egg came out amazing, Even when my AMS was done using one red spool of polyterra PLA it started printing with another Red filament and I think it looks pretty nice! Thanks, for the amazing model! This will be going towards easter tomorrow.