I had some left-over wire taking up space on really large spools. I looked for a smaller wire spool to print, but didn't find one to my liking. I created the OpenSCAD model to be able to make any size spool you could want, within the limitations of your printer. OpenSCAD code here: https://makerworld.com/en/models/51883

These are a couple variations of the Tie Fighter wire spool. The gray Tie Fighter in the photos is at default dimensions, 75mm outer diameter, 40 mm wide.

This is a 1-piece model that requires supports. You'll want to print in the default orientation of the STL to minimize support requirements.