Semi-circular Remote and Coaster Holder by Ken Mills

Ken Mills

Household>Decor

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

Remote Holder - 0.2mm layer, 2 walls, 10% infill

Designer

2.5 h

1 plate

4.6(17)

Remote Holder Coasters - 0.2mm layer, 3 walls, 10% infill

Designer

43 min

1 plate

5.0(7)

Boost

144

133

Released

Description

This remote holder is reminiscent of an amphitheater or stage. Four remotes can be stored around a stack of handy coasters. The shell design keeps the holder light-weight and saves material and printing time.

The coaster profile is set for zero top and bottom layers to expose the 10% honeycomb infill. Feel free to experiment with the infill pattern and density, and top / bottom layers for achieve different effects. You can also use other circular coaster models, just be sure to scale them to 99mm or less to fit the holder.

Comment & Rating (35)

@rodunk2

Print Profile

Remote Holder - 0.2mm layer, 2 walls, 10% infill

absolutely love this. quick, easy print with given settings.

The designer has replied

@KenMills

Thanks!

@rodunk2

Love it; came out great!

The designer has replied

@KenMills

Looks great and fits in quite well with the Penguins coasters ;) Thanks for sharing!

@tinytim443

Print Profile

Remote Holder - 0.2mm layer, 2 walls, 10% infill

Came out great and works really well.

(Edited)

The designer has replied

@KenMills

Thank you for the great rating. I'm glad you like it!

@mattpenn673

Print Profile

Remote Holder - 0.2mm layer, 2 walls, 10% infill

Really happy with the results, nice and easy print. Well done :)

The designer has replied

@KenMills

Thank you!

@Silverhuskie

Print Profile

Remote Holder - 0.2mm layer, 2 walls, 10% infill

Strength Issue:Walls should be a bit thicker. Other then that; nice.

The designer has replied

@KenMills

Thanks for the feedback! I was trying to balance strength and filament usage ;) I will see about thickening the walls to strengthen it (which also make it heavier which is a good thing).

@Silverhuskie

Replying to @KenMills :

Idropped it once and the back wall broke xD Might as well be a bit under extrusion. Anyhow; perfect fit for my needs! Maybe 3 instead of 2 walls will do the trick!

(Edited)

@KenMills

Replying to @Silverhuskie :

Thinking about it more, the filament used could also be a problem. I have some filaments that would cause this print to be fairly brittle, especially at corners. I assume they just have lower layer adhesions and I just relegate them to test chunky or prints. My 6 year old still has one of this kicking around among her toys ;)