Michigan vs Everybody Light Box
Boost
9
12
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
5.7 h
2 plates
Boost
9
12
2
0
18
18
Released
Description
This is my fist attempt at making a light box. This was requested for a friend of mine. Hope you like it! If you have any issues please let me know! You can change the colors as needed. I personally used black as its most cost effective since I buy black in bulk.
Comment & Rating (2)
All
The print profile is no longer public
Other Issues:the front plate is smaller than the back plate, I sent file directly from my phone so I didn't do any scaling
The designer has replied
0
Reply
I see what happened. I had uniform scale on and messed up the scaling in the slicer. Thanks for letting me know. Uploading a fix now.
EDIT: This is now fixed. The Y scaling was set incorrectly resulting in the back box being too tall. I did keep the front the same size so you can re-print the back and it should fit correctly now.
(Edited)0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld