Jewellery box with an insert part
Copyright Claim
Jewellery box with an insert part
Boost
18
31
6
Print Profile(4)
box 0.2mm layer, 2 walls, 20% infill
Designer
2.8 h
1 plate
insert 0.2mm layer, 2 walls, 20% infill
Designer
1.4 h
1 plate
lid 0.2mm layer, 2 walls, 20% infill
Designer
1.1 h
1 plate
0.2mm layer, 2 walls, 20% infill
8 h
3 plates
Boost
18
31
6
0
57
58
Released
Description
Jewellery box with a lid and 7 trays in the bottom part and an insert with 9 trays. This is an upgraded version of my previos model https://makerworld.com/sk/models/99213#profileId-105799
Lid has to be printed with supports, because of a small overhangs, but the print comes out really nicely.
This one was printed with PLA, 20% infill and supports for the lid.
the size of the box is 12 x 12 cm, and 6 cm high. But you can size it as you need
Comment & Rating (6)
All
Print Profile
insert 0.2mm layer, 2 walls, 20% infill
it would be nice if the overall dimensions were listed in description.
The designer has replied
0
Reply
Hello, the size of the box is 12 x 12 cm, but the insert is already scaled to fit the box. If you want to change the dimension of any part, you have to make the same change in % on all parts of the print, then it will certainly fit.
0
Reply
Print Profile
box 0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
lid 0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
box 0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
insert 0.2mm layer, 2 walls, 20% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld