N - HO: SNCF V2 support wall

(French text at the end)

A work based on two photos published in a model railroad magazine: (Loco Revue hors série n° 81). You'll find them among the photos on this page.

The STL files allow you to obtain a 10 cm-high portion of a wall, with one or four arches. This height corresponds to possible use in HO. But rather than referring to a railway scale, you need to adapt the print percentage to your needs. For example, on my N layout, I need to fill a 6 cm gap under the track: I print the STL file at 60%.

As shown in one of the photos, there are four levels of finish on offer, from a smooth, concrete-like version to a fully textured version that resembles the Loco Revue photo. A choice that will not be without consequences for printing time... (RSI/24)

A work based on two photos published in a model railroad magazine: (Loco Revue hors série n° 81). You'll find them among the photos on offer.

STL files can be used to obtain a 10 cm-high portion of a wall, with one or four arches. This height corresponds to possible use in HO. But rather than referring to a railway scale, you need to adapt the print percentage to your needs. For example, on my N layout, I need to fill a 6 cm gap under the track: I print the STL file at 60%.

As shown in one of the photos, there are four levels of finish available, from a smooth, concrete-like version to a fully textured version that resembles the Loco Revue photo. A choice that will not be without consequences for printing time... (RSI/24)

PLA, nozzle 0.4