Amazing model, printed without a problem. However, the triangle color fill pieces bulged a bit and it seemed like it was too long, so I fixed it by making small cuts. I do not believe it was the model, but the fact I that I printed everything except the color fill out of black ABS, and used silk copper PLA for the color fill. The cuts are hardly noticeable and the whole stand is well designed.
looks good. easy to print. printed the main frame in ABS cf. the rest in pla. loves the look of it. except the angle is a little too steep to use. wrist aching after some time. haha.
Profile works! Overall recommended with a few caveats. There was a little bit of warpage from bed removal on main frame but could have been user error. I would have liked the frame flipped to have the textured/ smooth side facing out for better asthetics. Most of the trim fit in perfect, but the thin trim was difficult. I may reprint and test again. I'd suggest smoothing out the tops if you have that setting on your printer. Either way, it's a badass looking stand!