I designed this coaster set as a Christmas gift.

It leverages the textured PEI bed to give a nicer feeling to the touch and reduce the appearance of a 3D printed item.

The stand is printed on its side to reduce the filament changes (4 in total), hence it needs supports.

I provided the pre-sliced plates with the needed configurations for a successful set:

• At least 4 top/bottom layers to reduce the chance of infill becoming visible
• Supports only where needed
• The stand is oriented to maximize the cooling effectiveness
• Ironing on flat surfaces of the stand to facilitate support removal and a nicer finish
• 6 coasters and 1 stand

If you're printing multiple sets, I suggest printing several stands on the same plate to increase efficiency even more (I printed 3, but there's space for more)