SKADIS USB & SD Card Holder
Remixed by
Copyright Claim
SKADIS USB & SD Card Holder
Remixed by
Boost
4
16
11
Print Profile(2)
0.2mm layer, 6 walls, 25% infill
Designer
54 min
1 plate
0.2mm layer, 6 walls, 25% infill
59 min
1 plate
Boost
4
16
11
0
59
46
Released
Description
Small SD/USB holder for the IKEA Skadis pegboard. Prints without supports.
- 4x USB-A slots
- 4x SD card slots (full size)
- 5x Micro SD card slots
Comment & Rating (11)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
Buen diseño. encaja perfecto en el skadis y tiene lo necesario
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
The designer has replied
0
Reply
hey thanks for the feedback, but I can’t see what happened to the print and why the 3 star. thanks
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
the print profil is good but the hooks are a little bit to big
The designer has replied
0
Reply
Thanks for the feedback, though I’d look at dialling in your printer and flow as the hooks are perfect for me.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Support Issue:Not a print in place design, gotta add supports for the hooks, but lesson learned. the slots are also a bit loose for SD cards and USB sticks - with a bit of tweaking this would be a great storage solution
The designer has replied
0
Reply
Thanks for the feedback. I’ve printed this on my X1C several times using this profile. As you can see in the reviews, several other have too. I also don’t see where the slots are lose. Is your printer well tuned for tolerances?
(Edited)0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
(Edited)
Strength Issue
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld