Here I introduce you to my magnetic buildplate holder (6 plates)!
There are probably easier ways to store your buildplates, but for people who like magnets it's just the thing.
The printing takes around 6,5 hours and requires 230g of filament. You will also need the following magnets https://amzn.to/47mfPqt (affiliate link). You need a minimum of 12, but if you want more magnetic force, you can put up to three into each of the upper holes and even more in the holes at the lower side. I decided to use 2 in the upper holes and one in the lower holes.
The screws for attaching the holding plate to the wall may be a maximum of 4mm thick, the length depends on the type of wall you have.
Make sure your filament is calibrated, otherwise you will have problems while inserting the magnets and removing the support.
Please let me know if you have suggestions for improvement, happy printing :-)
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.