Hi thanks for your feedback. This model was made before the scanner was released the a rendering of the scanner I put the slot in the front to allow the handle to flex when putting the scanner in. This is the first comment saying it doesn't fit I will revise the model but if you was to increase the size by 1% or use a lower percent infill to allow the flex.

Thanks for the reply! I'm not into reprinting this, a slightly larger sized part will fit a bit better for sure but will still be not great as the inside faces are looking like a low polygon model with a lot of irregolar faces instead of one smooth oval shaped hole. A part from that there is a small "lip" or "ledge" down in the bottom part, that will probably prevent the scanner to be inserted completely unless you upscale a bigger value that will probably lead to rattling of the scanner when inserted. All good, i'm using it as is with the scanner inserted maybe 70%, works for now. Would probably redesign one myself if i need it a lot in the future, will see 👍