Samsung Galaxy Fold 5 Switch JOYCON Case
Samsung Galaxy Fold 5 Switch JOYCON Case
Boost
27
32
12
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Boost
27
32
12
0
52
32
Released
Description
Samsung Galaxy Fold 5 Switch JOYCON Case
NO SUPPORT NEED
ONLY 0.2mm & 0.4mm Nozzel possible
0.6mm Nozzle is too big for connecting the Joycon's
Rating for Support
Big THX
Comment & Rating (12)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Just a casual $4000 diy cloud gaming setup. Honestly though, never thought to use joycons and this model fits them very well. a little tight on the bottom corners holding the phone but 100% functional and solid feeling. Printed in PLA-CF and PETG-CF (bottom) for nice finishes. PETG-CF felt better in the hand but warped at the bottom with the default handy slicing so probably needs adjustments.
1
Reply
Hi, am I right in thinking this would work for a zfold 4?
The designer has replied
0
Reply
i dont have a Fold 4 to test it. Sry
This Print is for the Fold 5
0
Reply
I'm thinking it will. I'll print it tomorrow and let you know!
0
Reply
I printed and it works for fold 4. however, I have a phone case so I need to adjust it to be a little wider
1
Reply
Je l'ai imprimé, mais malheureusement je dispose du Fold 3 et ça ne passe pas, je suis tellement déçu... 😭
Serait-il possible de le modéliser pour le Fold 3 s'il vous plaît ? 😇
The designer has replied
1
Reply
Comme décrit, ce n'est pas pour le Fold 3 mais pour la Série 5.
D'après ce que je peux voir, vous avez de toute façon créé un remix qui correspond à l'épisode 3.
English->
As described, it is not for the Fold 3 but for the 5 Series.
As far as I can see, you've created a remix that fits episode 3 anyway
0
Reply
hi, sorry bit any chance to get an sti file? I just need it a little wider (about 1mm each side) to fit the case I have on
The designer has replied
0
Reply
Hi Galaxia,
then just try using the scaling option.
Hope it helps for you :-)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Came out great, pla warped a little after leaving it in the sun but it still works
(Edited)The designer has replied
0
Reply
i just use PETG
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
© 2024 MakerWorld