Jacksonville Jaguars LED light box
Copyright Claim
Jacksonville Jaguars LED light box
Boost
11
18
9
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
5.9 h
2 plates
Boost
11
18
9
2
38
48
Released
Description
Jacksonville Jaguars LED light box! Has a 12mm hole on the side for your cord to go through. I use LED light strips around the interior of the light box, connecting to an 8-10mm solderless clamp, which then goes to a switch adapter and finally inserting to the plug cord.
Comment & Rating (9)
All
Boosted
GREAT PRINT, Can you add a stand so it could sit on a shelf? I see some of the other light boxes have that option.
Love the print.
The designer has replied
1
Reply
i will as soon as I master them! lol
0
Reply
Boosted
THANK YOU
1
Reply
did you print this using AMS? if not, how did you manage the color changes?
The designer has replied
0
Reply
yes. you just assign a color to each body. I have them labeled with the colors needed.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Made this for my living room and the face is very very thin needs more strength in the front.
The designer has replied
0
Reply
Sorry you have had problems. Light box fronts are made thin for transparency. At most, the front is around 1mm thick, and in colored areas, a little over half a millimeter thick. Was there a problem with separation of colors or anything, or is the general complaint it's just thin?
0
Reply
What colors did you use?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
No more
License
This work is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld