Bambu P1 and X1 Screw On Poop Chute with Bin
Remixed by
Copyright Claim
Bambu P1 and X1 Screw On Poop Chute with Bin
Remixed by
Boost
65
129
44
Print Profile(1)
Default 0.2mm Standard Profile
Designer
4.5 h
1 plate
Boost
65
129
44
0
343
227
Released
Description
Screw on poop chute designed for P1P and P1S (unsure but probably works with X1). Uses a small bin at the end of the chute that can sit on a desk to collect excess filament. I created it as I didn't want to attach a chute using magnets but also didn't want it to be too hard to remove the excess filament when it had built up. Does not work with rear spool holder.
I used 2 M3x12mm screws to attach it where the chute normally attaches to the back of the printer.
Comment & Rating (44)
All
Print Profile
Default 0.2mm Standard Profile
This is EXACTLY what I needed! 1) I didn't want Magnetic, I wanted it to screw-attach, practically every design out there is magnetic, 2) it needed to not already include a dead-end on it to collect the filament. This fit the bill! Thank you!
GIF
1
Reply
Print Profile
Default 0.2mm Standard Profile
Printed out great, I created a version with a corner at the end that I may add later.
0
Reply
Print Profile
Default 0.2mm Standard Profile
Perfect addition to the P1S especially the ability to take the “bin” away to empty.
0
Reply
printed fantastic using brown lol generic filament on sport mode. no issues. well except one but it was me. I don't have an AMS so I need something that can be used with rear spool holder. my fault
0
Reply
Print Profile
Default 0.2mm Standard Profile
I was completely amazed by this print build the way it was able to print without supports and at a 45° angle straight up that blew my mind
0
Reply
Print Profile
Default 0.2mm Standard Profile
Good design, loved that the bin is removable. Perfect for smaller prints. If you do longer prints with more filament changes, expect to change this out every few hours, as it starts backing up into the poop chute within the printer itself.
0
Reply
Print Profile
Default 0.2mm Standard Profile
The design works exactly as advertised, and fits perfectly. Now I've being doing a bunch of multi colour prints I'm going to upgrade my bin size though as this one fills up too quick.
0
Reply
Print Profile
Default 0.2mm Standard Profile
only printed the slide but it exactly what I was looking for, walls a little thick, but works great
0
Reply
Print Profile
Default 0.2mm Standard Profile
Looks and works great. I don't print a lot of multiple material models, so this works just fine for my purposes.
0
Reply
great Work, Works perfect on p1s inside Ikea platsa cabinet.
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (2)
Related Models
© 2024 MakerWorld