2x2 ID Card Holder with RSA Token
Copyright Claim
2x2 ID Card Holder with RSA Token
Boost
4
10
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
56 min
1 plate
Boost
4
10
3
0
17
17
Released
Description
This is a first “beta” of an idea to hold 4 ID cards and a RSA token on a lanyard. The Lanyard fits very snugly, as I wanted it to be inserted and stay in place. The cards slide in/out easily… which might be a bad thing for someone, but they are easy to remove quickly with your finger on the back side.
Use just about any settings. 3 wall, minimum infill (10-15) or 100%… it doesn't matter too much as the parts that need structure will have walls completing it all.
Support: I used tree supports for the bridge on the front and the small curve on the back, but it technically works on an X1C without (although it does drupe a little).
Comment & Rating (3)
All
The RSA holder fits great and seems to holder the token tightly. Badges slip into each holder with no problem; however, there is no cover nor spring to hold the badges in. If the holder is turned over, the badges simply fall out. Some form of tension/spring needs to be added to make this fully functional.
The designer has replied
1
Reply
Yeah, I was torn on that one. I didn't know exactly how to make a good "spring" to hold 2 cards well... but also didn't, want them being hard to get in/out. It hangs in an orientation that they should just fall out randomly. Although, tossing a lanyard around, they might. I will eventually get back and 'fix' it, but currently can't.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld