Magnetic Slide for Bambu Poop Container by TheMiguelBi

TheMiguelBi

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 99% infill

Designer

3.9 h

2 plates

4.8(12)

Boost

121

Released

Description

Magnetic poop evacuation ramp for containers

Parts needed:

8x Cylindrical Neodymium Magnets [5mm, ⌀5mm]
4x Neodymium Magnets [⌀10mm, thickness 2mm]

The cylindrical magnets are inserted by pressing. If necessary, secure them with 1 drop of glue.
While the 4 button magnets require glue. Use paper tape to keep the magnets in place.
Once the glue has dried, the magnetic ramp will be ready to evacuate your poop!

----------------------------------------------------------------------------------------------------------------------------------------------------------

ATTENTION!
This version with magnets works perfectly on X1C models (metal rear body).
So pay attention to this if you have a P1P or P1S model!

-----------------------------------------------------------------------------------

If you occasionally find poop leaking, try this in combination with the magnetic ramp: https://makerworld.com/en/models/163896#profileId-179900

And to ensure the closure of your Container,
you can use this mini-padlock of mine:

https://makerworld.com/it/models/84815

Happy Evacuation! ;)

magnetic slide for container

Comment & Rating (20)

@STLDad6

Did this whole project today. from crate to ramp to lock.

The designer has replied

@TheMiguelBi

Thank you so much for sharing your prints!

@TheMiguelBi

Since I occasionally find "leaks" coming out, I drew and added this, if you're interested: https://makerworld.com/en/models/163896#profileId-179900 Ciao!

@projecteae

Print Profile

0.2mm layer, 2 walls, 99% infill

The profile is fairly solid. Good clearances on brims and support so everything prints decently with easy removal. Magnets all fit well. The 10x2 magnets DO fit on P1S, but since its not as strong since its not all metal panels- it can fall off easily while positioning the purge bucket. I'll like have to go with another model that has support legs for the P1S. But I'm definitely saving this for when I get an X1C next!

(Edited)

The designer has replied

@TheMiguelBi

Thank you for rating and sharing the print. (Nice polycom VVX500/501 on the back! 😉)

@Regarnogal

Print Profile

0.2mm layer, 2 walls, 99% infill

worked perfectly on P1S, but I had to improve it with stands from another Modell, cause P1S isn’t magnetic ;) thank you!

The designer has replied

@TheMiguelBi

Oops. Excuse me! I only own "X1C Carbon". I thought the back part was metal on the other versions too. (I'll immediately add a note to the description). Thanks for sharing the print!

@TheMiguelBi

If you occasionally find poop leaking, try this in combination with the magnetic ramp: https://makerworld.com/en/models/163896#profileId-179900