Slim Poop Chute Removable Bin Remix Remixed by minist3r

Remixed by

minist3r

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 7% infill

Designer

4.3 h

1 plate

4.6(86)

Boost

102

105

456

445

Released

Description

This is a remix of my slim poop chute with a removable bin. I had 3 requirements that I wanted to meet: 1. Under 200 grams of filament. 2. Easy to print and no supports. 3. It has to function well (I took a picture of where the first poop fell). I removed the wall against the printer since it seemed unnecessary but the over all dimensions are the same. The chute has a tapered base that matches the the taper in the bin for easy alignment back on the chute.

Updated design from community feedback:
https://makerworld.com/en/models/398260#profileId-299770

Comment & Rating (105)

@DustinS

Print Profile

0.2mm layer, 2 walls, 7% infill

Walls on the top are a little thinner than I was expecting but it printed like a champ. Just what I was about to design when I found it.

The designer has replied

@minist3r

Looks good. I wanted to keep things as thin as reasonable to cut down on filament requirements.

@DustinS

Replying to @minist3r :

I figured and completely understand. Doesn’t need to be thick in the places that it isn’t so works great. Thanks for creating it

@minist3r

Replying to @DustinS :

Thanks for the print and rating. Now if I could just get my reward points out of Bambu jail...

@jonathandavis91

wonderful print. came out perfect. thank you!

The designer has replied

@minist3r

Looks great.

@user_2847311812

Print Profile

0.2mm layer, 2 walls, 7% infill

printed perfectly. exactly as described.

@Dunkelziffer

Print Profile

0.2mm layer, 2 walls, 7% infill

Very useful for tight places

@user_1466707661

Print Profile

0.2mm layer, 2 walls, 7% infill

print lovely on my P1S works a treat thanks for the model

@kyle.e.hansen

Print Profile

0.2mm layer, 2 walls, 7% infill

printed awesome! love the design. thanks!

@Phantom78

Print Profile

0.2mm layer, 2 walls, 7% infill

works as it should, thank you

@HiddenAcres

Print Profile

0.2mm layer, 2 walls, 7% infill

Printed nice and clean on one plate. Fits the curve of the P1S perfectly. Finish on the slide feels smooth, so the waste should slide right down.

@user_959737082

Print Profile

0.2mm layer, 2 walls, 7% infill

@sabitoe

Does it also fit for the P1S?

The designer has replied

@minist3r

It should since I'm pretty sure the radius of the back left corner is the same as the X1C but I don't have a P1S to test it with.

@spate_dells0f

Replying to @minist3r :

It looks to fit the radius of my P1S perfectly, however the back wall appears to be a couple inches too short, at least for my printer. The poops over shoot the chute

@minist3r

Replying to @spate_dells0f :

Is the chute of the p1s different?