Flowers plant pot
Flowers plant pot
Boost
170
238
35
Print Profile(1)
0.28mm layer, 2 walls, 15% infill
Designer
7.9 h
1 plate
Boost
170
238
35
1
501
243
Released
Comment & Rating (35)
All
Print Profile
0.28mm layer, 2 walls, 15% infill
very nice. sadly dond hold water, but some epoxy will deal with that problem
The designer has replied
0
Reply
normally they should hold water, we have never had one that didn’t hold water
0
Reply
Replying to @T3DObjects
yea, mine was leaking from the bottob after some minutes already. But other than that, very pretty design
0
Reply
Nice Model
The designer has replied
1
Reply
Thank you!😊
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
Works well, printed without issues, even scaled down
2
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
nice model
1
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
wonderful design! This was easy to print (no supports required) Looking forward to printing a few more colors. :) Thanks to the designer for your hard work.
(Edited)
1
Reply
Boosted
Lovely design! I started printing with yellow and ran out then continued in pink, a mistake but it makes the pot look even better. Keep up the good work :D
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
1
Reply
what are the dimensions of this print?
The designer has replied
1
Reply
this print is 12,5 cm x 9,5 cm
0
Reply
thank you
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
Really cool print! My wife loved it
The designer has replied
1
Reply
Thank you!!
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld