20mm Picatinny Riser for Airsoft by OrangeSockNinja

OrangeSockNinja

Hobby & DIY>Sport & Outdoors

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.08mm layer, 4 walls, 15% infill

Designer

1.9 h

1 plate

4.5(4)

Boost

Released

Description

This is my own take on a Picatinny rail riser for airsoft. This was designed for M2 hex screws and nuts, specifically socket head cap screws like these: https://www.amazon.com/gp/product/B082XRX17Z/ref=ppx_yo_dt_b_asin_title_o03_s01?ie=UTF8&th=1 You'll need 2 M2*10 screws and 2 nuts.

This is designed to fit standard Picatinny, and it fits on all 3 of my airsoft guns from various manufacturers. However, since the tolerances are pretty tight, they might need slight filing or sanding to fit. I didn't deal with any issues, however. I reccomend PLA Tough, but other filaments will work. The riser in the pictures is black PLA Basic and it works just fine.

When NOT in use on a picatinny rail, please DO NOT fully tighten the screws. This riser is designed to form fit to the picatinny rail, but if tightened off of rail it may bend the M2 screws or break the plastic.

Happy airsofting! This is my first foray into Picatinny so I'm very proud of this model.

Comment & Rating (4)

@Bolgechips

Print Profile

0.08mm layer, 4 walls, 15% infill

god qullaty but call for small hardware it can be har to finde

@PrecisionPrintA

Print Profile

0.08mm layer, 4 walls, 15% infill

Printed in Bambu PLA matte using provided profile. print quality was good the tolerances are super tight not quite loose enough to allow the M2 screws to slide freely in the hole making it a bit tiedious to get them in as well as the side where the nut goes is a bit too tight to allow the nut to fit I had to use a blade and shave the edges just slightly to get it set in there. Still a great quality print these are just minor changes that could be made.