Super Mario Bros - 1 up mushroom container - for 3DS, Switch, or for Jewelry.
Copyright Claim
Super Mario Bros - 1 up mushroom container - for 3DS, Switch, or for Jewelry.
Boost
16
21
3
Print Profile(2)
Beauty Setting this is the 0.16, but with the outer walls at 50mm/s to improve surface finish.
Designer
27.9 h
3 plates
0.16mm layer, 2 walls, 15% infill
32.2 h
8 plates
Boost
16
21
3
0
43
23
Released
Description
This is my Super Mario Bros. 1up Mushroom from the game and movies. The cap is easily printed in a single color and assmebled afterwards. Then print one of the three inserts in black to give the “eyes” contrasting color. the white caps for the mushroom are threaded in. Print and thread in easily… these are not meant to come in and out all the time. The cap is made to be ¼ turn on and off. Enjoy.
Comment & Rating (3)
All
Print Profile
Beauty Setting this is the 0.16, but with the outer walls at 50mm/s to improve surface finish.
I printed a one up. it would be really nice to see a remix of flush white spots on the head instead of bulges. and without the hanging holes at the top as well. otherwise fantastic print.
0
Reply
Print Profile
Beauty Setting this is the 0.16, but with the outer walls at 50mm/s to improve surface finish.
0
Reply
Print Profile
Beauty Setting this is the 0.16, but with the outer walls at 50mm/s to improve surface finish.
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld