Modular Hydroponic Tower Garden (Electric Cap)
Remixed by
Boost
12
41
11
Print Profile(1)
PETG 0.2mm layer, 2 walls, 20% infill
Designer
1.3 h
2 plates
Boost
12
41
11
0
87
73
Released
Description
The model comes in 3 parts, all can be printed without supports - the symbol needs to be glued in and is about 0,1 mm recessed
so no multi material or multi color printer needed
Comment & Rating (11)
All
Print Profile
PETG 0.2mm layer, 2 walls, 20% infill
super
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 20% infill
printed great
0
Reply
So we print an extra section for filling the res?
Then cap it off?
The designer has replied
0
Reply
if you want it "pretty" yes - but you also can just remove the top cap and refill from there - if you use a white translucent bucket, you'll see the water level, so no dedicated filling port needed
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 20% infill
super, passt genau
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 20% infill
everything good, the cut to fit cable need to be wider for pumps with bold cables
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 20% infill
perfect fit
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
PETG 0.2mm layer, 2 walls, 20% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld