Plant shovel
Plant shovel
Boost
12
42
10
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
2.3 h
1 plate
Boost
12
42
10
0
126
69
Released
Description
Printed in PETG (print with smile) RUBIN RED (just because i want to get rid of it)
Its a light use item, no need for 100% fill. i printed with 3 perimeters and 20%infill.
NOT FOR COMMERCIAL USE OR TO MAKE MONEY OF.
PRINT IT FOR YOURSELF OR YOUR BETTER HALF
i printed it laying like shown with no supports, worked well. Print time: 4h 40 min.
Print Settings
Printer:
PRUSA MK3S+ CLONE
Rafts:
No
Supports:
Not needed with properly tuned printer
Perimeters:
3
Infill:
20
Filament:
PRINT WITH SMILE PETG
RUBIN RED
Category: Outdoor & Garden
Comment & Rating (10)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
A little rough with petg, but its fine. Scaled it down 80% for my girlfriend.
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Better than I expected. the raft/brim was a pain to get off, and maybe requires some sanding, but we had it out in the snow fort yesterday chipping away at hard snow and it held up pretty good. printed using PLA generic.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
ok
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
that is very good
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Support Issue
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld