YOU CANNOT SELL THIS WORK
In order to sell this work you must purchase a commercial license from the makers of Hueforge. I just have a public license so I am able to share the STL file I made for free!

Here is the link to the creators program to purchase!
https://shop.thehueforge.com/collections/hueforge
---------------------------------------------------------------------------

Bambu P1S - printed using an 0.4mm nozzle and 0.04 layer height, but you will get better results using an 0.2mm nozzle. Slow the speed down by about 25% speed total (even slower than Bambus silent mode)

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm

Filaments Used:
PLA Elegoo Black - Rapid PLA+ Transmission Distance: 1.5
PLA Inland Purple - PLA+ Transmission Distance: 2.5
PLA Inland Egyptian Blue Transmission Distance: 3.5
PLA Elegoo White - Rapid PLA+ Transmission Distance: 9.5
PLA+ Sunlu Red Transmission Distance: 6
PLA Elegoo Pink - PLA+ Transmission Distance: 7.2
PLA Elegoo Orange Transmission Distance: 12
PLA Elegoo Beige Transmission Distance: 8.8
PLA PolyLite Yellow Transmission Distance: 11

Swap Instructions:
Start with Black - Rapid PLA+
At layer #3 (0.24mm) swap to Purple - PLA+
At layer #7 (0.4mm) swap to Egyptian Blue
At layer #12 (0.6mm) swap to White - Rapid PLA+
At layer #13 (0.64mm) swap to Red
At layer #24 (1.08mm) swap to Pink - PLA+
At layer #28 (1.24mm) swap to Orange
At layer #32 (1.4mm) swap to Beige
At layer #44 (1.88mm) swap to Yellow for the rest.

---------------------------------------------------------------------------