Pixel 8 Pro TPU Case
Copyright Claim
Pixel 8 Pro TPU Case
Boost
31
39
15
Print Profile(1)
0.16mm layer, 10 walls, 15% infill
Designer
5.6 h
1 plate
Boost
31
39
15
0
165
88
Released
Description
This pixel 8 pro case is designed to be printed in TPU. I designed the case to protect as much of the phone as possible without being too bulky. There are only 3 small areas that need support (speaker/mic holes), which the support material pulled off pretty easy. The case model is solid and I removed the top and bottom layers in Bambu Studio to show the infill on the back of the phone, that way you can select whatever infill you like the pattern of and tweak the settings to get different results. I have tested it, and it still works with wireless charging on the pixel stand chargers (1 and 2), other chargers may or may not work, not sure as I don't have other wireless chargers.
Comment & Rating (15)
All
hi, why i ve not the honeycomb file??
The designer has replied
0
Reply
Hi, I made the model solid and then set the top and bottom layers to zero in the slicer and then set the infill to honeycomb which then shows the honeycomb pattern since there isn't any top or bottom layers. Doing it that way made it so you can easily switch patterns by just changing the infill pattern in the slicer without remodelling.
1
Reply
Print Profile
0.16mm layer, 10 walls, 15% infill
Great print!
I may try to scale the sides down a bit, pretty chunky, but i feel like this is a great case and will protect my phone!
Printed with generic white TPU.
(Edited)
0
Reply
Print Profile
0.16mm layer, 10 walls, 15% infill
printed fine on the a1 mini in tpu
0
Reply
Print Profile
0.16mm layer, 10 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.16mm layer, 10 walls, 15% infill
I've already dropped my phone and the case protected it.
The designer has replied
1
Reply
glad it helped :)
(Edited)1
Reply
Print Profile
0.16mm layer, 10 walls, 15% infill
Thanks so much for this. Printed two to hold us over until our dbrand cases arrived and they were comfortable and fit great.
The designer has replied
0
Reply
No prob, glad you liked it. :)
0
Reply
Print Profile
0.16mm layer, 10 walls, 15% infill
Schnelle, einfache Lösung.. Hat auf Anhieb funktioniert.. Passt gut.. Nur die Stützen waren bissil schwer abzukriegen.. Danke an den Urheber..
0
Reply
Print Profile
0.16mm layer, 10 walls, 15% infill
printed well in TPU, good fit, bit square and blocky for my liking though
0
Reply
Print Profile
0.16mm layer, 10 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 10 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld