Enterprise-A Constitution Refit by martin.taichl

martin.taichl

Hobby & DIY>Vehicles

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

more colored version

38.3 h

11 plates

4.8(9)

Boost

127

226

439

357

Released

Description

This is 3D printable model of the Constitution Refit NCC-1701-A Enterprise from the Star Trek. It is a kit and does not require any glue. The different colored parts are separated for easier printing.

Pieces of the necelles need to be separated into separate model in the slicer ;)

For the assembly, please have a look at the following video.

Comment & Rating (15)

@w3r3wolv3s

Boosted

Print Profile

more colored version

First off, I'd like to thank the designer for uploading such a detailed and beautiful model. Amazing work. Second, in the interest of helping others avoid frustrations, I did have a few issues. The primary one is that the "MT" logo in a circle on the back of the saucer section wasn't completely attached to the model. Other than that, several parts took a fair amount of sanding or trimming to fit. Several of the small parts had to be re-printed from 3-8% smaller to fit.

The designer has replied

@w3r3wolv3s

Boosted

In the end, she came out beautifully and looks great on my desk. Cheers!

@cv6Channel

The tightness can depend on a not perfect flow rate for your filament. I also had this issue during the creation of the print profile. Its really important to have the perfect flow rate. Run a calibration before if it does not fit. Martin did a really good Job in designinf the ships. And if all is perfect printed, even without glue its stable.

@berdenventure

Print Profile

more colored version

Print was perfect

@jeffrudzinski.p

Print Profile

more colored version

This is the coolest thing I've 3D printed. Some of the accent parts could be fit a little better but that's a minor thing. A simple coat of primer and some Testors metalic paint work great.

(Edited)

@user_3092485609

Great model...fun to print and put together! Had some minor issues with some of the accent parts being a little tight but was able to scale them down as necessary...otherwise everything fit great! Here it is sitting next to his other model of the Enterprise 1701...also an awesome model.

@sicco.miedema

Print Profile

more colored version

beautiful model. the design snaps together perfectly and only requires a few drops of superglue.

@cv6Channel

Awesome model! i added my Print Ptofile if someone want to print is also. I seperated the colors, added rims when needed and prepared a lot. Thank you Martin for this cool model.

@vandal968

Love this model. Who's blue/gray filament did you use for the warp nacelles? The blue I used is too bright.

@peterhosking197

I did do a littler adjusting on some of the clips..But can I just thank Martin for letting us download your design.Just need the Reliant to go with this.