Filament clamp
Copyright Claim
Filament clamp
Boost
19
42
28
Print Profile(1)
PETG, 0.16mm layer, 5 walls
Designer
51 min
1 plate
Boost
19
42
28
0
135
111
Released
Description
A simple but Sturdy filament clamp
A stable clamp to fix the filament to the spool. This prevents the filament from being kinked when it is pushed through the side holes.
The clamps are best printed in PETG
Comment & Rating (28)
All
Print Profile
PETG, 0.16mm layer, 5 walls
It doesn't hold, it slides on the spool and your filament just isn't held tied enough.
The designer has replied
0
Reply
Hello, normally the clamp holds well and the filament is also held well. It may be due to the filament used (too soft) or the print quality. The best results are achieved with PETG as it is slightly stronger than PLA.
0
Reply
Replying to @Staprin3D
I have also uploaded a modified print profile for PETG with more Wall thickness so you can try again
0
Reply
Print Profile
PETG, 0.16mm layer, 5 walls
I love the simple designs. I color coded each one to match the filament. I also spread them out on the plate and changed the print to print by object to minimize color changes, poop, and that tower thing. :)
1
Reply
Print Profile
PETG, 0.16mm layer, 5 walls
Perfect
0
Reply
Print Profile
PETG, 0.16mm layer, 5 walls
zieht Fäden, aber Qualität sonst top
0
Reply
Print Profile
PETG, 0.16mm layer, 5 walls
For being new to 3D printing and not having all the fancy spool accessories, these are fantatic for preventing tangles.
0
Reply
Print Profile
PETG, 0.16mm layer, 5 walls
Hammer Idee. Qualität ist perfekt
0
Reply
Print Profile
PETG, 0.16mm layer, 5 walls
0
Reply
Print Profile
PETG, 0.16mm layer, 5 walls
0
Reply
Print Profile
PETG, 0.16mm layer, 5 walls
0
Reply
Print Profile
PETG, 0.16mm layer, 5 walls
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld