Flexi Hammerhead Shark(print-in-place)

Extra service "Flexi Hammerhead Shark - New Type, and Mini Set" released!!
If purchased, commercial use license and 3mf files are available.

3dflexseeds

Flexi Hammerhead Shark - New Type, and Mini Set(Print-in-place)

• 3.2k views
• 16 likes
• 54 downloads
• 1 collection
• 0 comments
• 0 makes

Download US$3.49

3dflexseeds

Flexi Hammerhead Shark Mark-Ⅱ(print-in-place)

• 4.5k views
• 14 likes
• 46 downloads
• 1 collection
• 0 comments
• 0 makes

Download US$3.15

[Update]
---2023/05/10---
Version 2 with stronger joints has been added.
---2023/05/26---
New Type released!!
https://www.thingiverse.com/thing:6046050
---2023/09/25---
Fixed a defect in version 3 where the joints of the tail and tail fin were not connected.

{Description}
This is the hammerhead shark Flexi.
No support or assembly is required, just 3D print and play.

💰Commercial Use💰
This model is not available for commercial use under "CC BY-NC-ND 4.0" below.
Therefore, I am selling the upgraded model with additional detailing and a license for commercial use.
If you want to sell my model commercially, please check my Cults.

⚠Warning⚠
Be careful in environments with young children and pets!
This model contains small parts. If not properly stored in an environment with young children or pets, it may lead to accidents such as accidental ingestion or injury. If infants or pets are present, please take appropriate measures depending on the situation, such as refraining from 3D printing or storing in an appropriate place.

Do not apply strong force!
Applying strong force to a 3D printed model or throwing it may damage the model and lead to accidents such as injuries. In addition, debris from damage to the model may be accidentally ingested by infants or pets. If the model is damaged, dispose of it immediately.

Store them in an appropriate place.
After 3D printing, store the model in an appropriate place out of reach of young children and pets. Proper adherence to the precautions will ensure safe use of the model.

Rafts:No
Supports:No
Layer Height: 0.1-0.3 mm
Infill:15-20%
Filament material: PLA

{Recommend}
Layer Height: 0.2mm
Print Speed: 60mm/s
Outer Wall Speed: 10mm/s
Z Seam Alignment: User Specified
Z Seam Position: Right
Z Seam Corner Preference: Hide Seam
Bulid Plate Adhesion Type: Skirt or None