iPhone 15ProMax case
Copyright Claim
iPhone 15ProMax case
Boost
9
14
7
Print Profile(1)
0.16mm layer, 3 walls, 20% infill
Designer
1.5 h
2 plates
Boost
9
14
7
0
81
30
Released
Description
I like a minimal case, but wanted to have a design on the back.
This one can be printed in PLA as is, no supports, and can just snap on. It's a tight fit, but will fit.
The “Camera Bump" is to help protect the lenses, but is printed separately to avoid supports. The holes in the case and bump will take a bit of filament as alignment aids for gluing.
The button extensions ease button activation, but could be optional if you prefer to use a fingernail.
I wanted the octopus backing, but toyed with a few others. I included a blank edge, and a few alternate backs which could be combined in TinkerCad or whatever, or create your own. Created with OnShape.
Comment & Rating (7)
All
printed easy, VERY tight fit. I realized I forgot to print the buttons and it is a bit tricky without them but still usable.
0
Reply
@Bird2brain, thank you for the case. What I like about the case is that you get to see the Titanium case of the iPhone, yet it's extra protection. Just one question, when printing the other backs, do I print them separately and then put them together? Or do I have to combine the frame with the back in the slicer?
The designer has replied
0
Reply
Sorry to take so long to respond. Combine the back and the sides with Tinker cad before printing.
0
Reply
Sorry for the delay. Combine them in TinkerCad (or equivalent. Once you get it, you can create your own fairly easily.
0
Reply
Print Profile
0.16mm layer, 3 walls, 20% infill
works well but hard to take off if made in PLA.
0
Reply
Print Profile
0.16mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 20% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld