Mag-Seal Commander Display Deck Box
Copyright Claim
Mag-Seal Commander Display Deck Box
Boost
41
62
15
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
3.2 h
1 plate
Boost
41
62
15
0
120
199
Released
Description
I designed this magnet-seal commander display box to use low amounts of filament, be tough, and look good! You can use the box without magnets, however I recommend using them because of the satisfying click and the magnets being very cheap ($5). Also, if you add a pause and change filaments, you can create multicolor deck boxes like shown in the picture!
If you have and questions or suggestions, let me know!
Comment & Rating (15)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
front of box needs wider to take a hard plastic still a great box for starter 3d print ran into issues with my print of glue dry and lid peeled up and flew off 3 times until raise the print bed heat 100 c in p1p it warp the lid some but quick blend back into sharp as still had heat and fix the issue too all in all its good box. Keep in mind this was 2nd print ever bunny was my 1st
(Edited)
0
Reply
if there's room making the slot wide enough for top loaders to protect the commander would be great!
The designer has replied
2
Reply
Plus 1. I really like the deck box and i don't mind if i can't double sleeve my deck, but a room for the toploader would be awesome.
0
Reply
Im sorry. This box was specifically designed to not use a toploader
1
Reply
Does this work with double-sleeving?
The designer has replied
0
Reply
It does not
(Edited)1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
great job a little warping on the base.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
been working perfectly
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld