VW Bus “Surfing Lifestyle” Hueforge print. 200mm x 160mm
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA+ Sunlu Black Transmission Distance: 0.6
PLA+ Sunlu Sky Blue Transmission Distance: 8.6
PLA+ Sunlu Sunny Orange Transmission Distance: 5
PLA+ Sunlu White Transmission Distance: 5
Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Sky Blue
At layer #14 (1.2mm) swap to Sunny Orange
At layer #19 (1.6mm) swap to White for the rest.
if you want to change your slicer and do it at 0.04mm Layer height use the setting below, this is what I printed the included photo at. takes to long to slice so kept erroring out on Makerworld.
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm
Filaments Used:
PLA+ Sunlu Black Transmission Distance: 0.6
PLA+ Sunlu Sky Blue Transmission Distance: 8.6
PLA+ Sunlu Sunny Orange Transmission Distance: 5
PLA+ Sunlu White Transmission Distance: 5
Swap Instructions:
Start with Black
At layer #12 (0.6mm) swap to Sky Blue
At layer #22 (1mm) swap to Sunny Orange
At layer #31 (1.36mm) swap to White for the rest.