Coin Vortex Piggy Bank
Copyright Claim
Coin Vortex Piggy Bank
Boost
19
32
5
Print Profile(2)
Coin Vortex Piggy Bank - 0.2mm layer, 2 walls, 10% infill
Designer
5.3 h
1 plate
Coin Vortex Piggy Bank - Two Plates - 0.2mm layer, 2 walls, 10% infill
Designer
6 h
2 plates
Boost
19
32
5
0
61
38
Released
Description
Enjoy the mesmerizing spinning journey of coins as they make their way into the bottom of this hyperboloid coin bank.
The ramp simply snaps snuggly onto the vortex rim. Lay a coin flat at the top of the ramp, release and enjoy.
Prints easily in two pieces. Be sure to fully remove all brims if used.
Coin ramp based on a model by 3D-NM80R found here: https://www.instructables.com/COIN-VORTEX/
Comment & Rating (5)
All
Print Profile
Coin Vortex Piggy Bank - Two Plates - 0.2mm layer, 2 walls, 10% infill
printed well. thanks
0
Reply
Print Profile
Coin Vortex Piggy Bank - 0.2mm layer, 2 walls, 10% infill
using it for a change collection fund raiser at school
0
Reply
Print Profile
Coin Vortex Piggy Bank - 0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
Coin Vortex Piggy Bank - 0.2mm layer, 2 walls, 10% infill
(Edited)
0
Reply
Print Profile
Coin Vortex Piggy Bank - 0.2mm layer, 2 walls, 10% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld