Spray Can Handle
Copyright Claim
Spray Can Handle
Boost
59
123
18
Print Profile(2)
0.28mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
X1C 0.2mm, 4 walls for strength, 15% infill, short handle
1.6 h
1 plate
Boost
59
123
18
2
142
115
Released
Description
Handle for spray paint can, you can tighter the collar with zip ties or and m4 nut and bolt. Attach the handle with a m5x15mm bolt and nut that acts as the pivot.
Comment & Rating (18)
All
great idea. Thanks a lot.
0
Reply
This design is great! I printed it in Bambu Basic PLA Black. I printed this with extra walls for strength.
Initially I printed both handles (short and long) but I found that the long handle doesn't always pull straight back and wouldn't activate the paint. So I use the small handle and find that it works much better.
The only thing I wish for is an easier method for installing and removing as it is a little time consuming when using lots of cans.
0
Reply
Boosted
Great design works very well, I added knurled handles for easy mounting
https://makerworld.com/en/models/74918#profileId-79360
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
fast and functionnal, work with colring
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
it printed very well, printed two of them. I would recommend to increase the infill though, I broke one when it fell off a table.
1
Reply
Boosted
very good and easy to print
0
Reply
Print Profile
X1C 0.2mm, 4 walls for strength, 15% infill, short handle
Works well, Used it yesterday with no issues.
0
Reply
Print Profile
X1C 0.2mm, 4 walls for strength, 15% infill, short handle
Works as intended
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
What a fantastic print. i am disabled and this helps me spray prime my models. thank you.
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
turned out great , thanks!
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld