works great

looks great, but first was a bit tight and doesn't quite close for Mr. good enough for what I need though

The PLA-profiled case was successfully printed without any issues, resulting in a visually appealing product. I've integrated a Raspberry Pi 5, 8 GB version board into the case, and here are my observations: 1. The case provides a snug fit, requiring some force to secure the board in place. 2. The dividers between the USB ports and Ethernet port could benefit from being slightly thinner in width (approximately 0.5mm less) to facilitate easy insertion of the ports. This adjustment should also be considered for the micro HDMIs and the power port, as the tight fit has led to cracks developing at the corner near the power port. 3. Adding four legs to the bottom plate would enhance ventilation when the case is positioned on a flat surface. 4. Consider incorporating text labels such as "Reset," "USB," "HDMI 1," etc., to further enhance the case's usability and aesthetics. I appreciate your efforts in creating such a beautiful case. Thank you!

nice print the 5 in the raspberry is a little small maybe the .2 nozzle could print it not sure but its small. fits nice and tight even with the OEM heat sink fan

Great Print!

Case works well but clip on one side was a bit flimsy and snapped off when trying to close the first time. Taped it shut and it works well.

looks professional and works

Printed again, really does seem the active cooling push pins get in the way for the bottom half. Top half fits fine though, but you need both halves

Bottom half isn't compatible with active cooling push pins or at the very least isn't deep enough to give enough clearance to insert micro SD

Mein Vater hat sich sehr gefreut paßt sauber für sein Rasperry