Splat! mobile phone stand
Boost
201
279
24
Print Profile(1)
No supports, variable layer height, 2 walls
Designer
6.3 h
2 plates
Boost
201
279
24
0
411
171
Released
Description
Splat! mobile phone stand
Add some fun to your office or bedside table! Simple print requiring no supports. Choose a colour and print your splat!
There are two versions available, the original and one with a hole to pass a lightning charger through. I would recommend supergluing the charging connector in place to stop it moving when placing the phone down to charge.
Comment & Rating (24)
All
Print Profile
No supports, variable layer height, 2 walls
nice
The designer has replied
1
Reply
Looks great!
0
Reply
Print Profile
No supports, variable layer height, 2 walls
Came out great!
The designer has replied
1
Reply
Looks great! thanks for sharing
0
Reply
Print Profile
No supports, variable layer height, 2 walls
BambuLab PLA White Matter
The designer has replied
0
Reply
That looks great! Thanks for sharing.
0
Reply
👍
1
Reply
Print Profile
No supports, variable layer height, 2 walls
most USB c cords will not fit in hole but pretty neat otherwise.
The designer has replied
0
Reply
Thanks for your feedback, I have now updated the model with a larger hole so it's compatible with more connectors.
(Edited)1
Reply
Print Profile
No supports, variable layer height, 2 walls
design is cool but I haven’t found any phone charger that even remotely fit in the provided hole
The designer has replied
0
Reply
I sized it to fit the Apple lightning charger that comes with the phone. I’ll enlarge it a bit when I can though so more will fit.
0
Reply
Print Profile
No supports, variable layer height, 2 walls
This phone holder it's beautiful, but i have a problem with the cable inside the print
0
Reply
Print Profile
No supports, variable layer height, 2 walls
It prints very nice, the only problem is that the hole for the cable is too small but that is a problem of the model.
0
Reply
I think is better expand the hole because i cannot insert the cable. I think if you expand the hole for the connector and the wire is better.
0
Reply
Print Profile
No supports, variable layer height, 2 walls
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld