Holster to hold your can of Zyn. It easily attaches to your belt, radio rig, or any other type of strap that has a width similar to a belt (approx. 1.5").

Theres a built in detent inside the lower half that will securely lock your can in place along with the holsters snug fit. It is physically impossible for your can of Zyn to fall out on its own or due to any bumps or drops.

The holster prints in 3 pieces.

Hardware you will need for assembly:

x2 M3x6mm fine thread hex button head socket cap screws.

x3 M3x12mm course thread hex socket cap head self tapping screws.

x2 M3x4x5mm brass female threaded heat-set inserts.

the pictures explain where the hardware goes during assembly.