首先感谢JAV-3D分享了底座STP文件
我在此基础上做了一些修改
1、改进了散热，去除了两侧的围墙使得空气能够流通，蜂窝结构也是为了更好的散热，但实际上蜂窝结构不能很好的起到作用，大家可以在STP文件中去除蜂窝结构。
2、底座的上面我设计了放置三包凭证以及入门指南的凹槽，可以防止他们丢失。
3、我设计了两个抽屉，一个在前面，另一个在后面。
4、我认为官方送的工具收纳盒子是很完美的，所以我倾向于保留官方送的盒子，将其放置在了前面的抽屉中。
5、我很喜欢官方的胶水，也将其放置在了前面的抽屉中。
6、后面的抽屉是按照A1mini的打印尺寸设计的，大家可以在STP文件中进行修改，将其扩大。
7、我设计了磁铁对构建板、前面抽屉、后面抽屉、侧边放垃圾的盒子进行吸附，但是效果不是很好，大家可以在STP文件中进行修改，不放置磁铁也是可以正常运作的。

8、Z轴如果添加了过多的润滑油，它会通过机器下部流出，请注意这一点，非常重要！！！

9、为了防止偏移，需要在底部添加直径20mm，高度5mm的软垫。

First of all, thank you to JAV-3D for sharing the STP file of the base

I made some modifications based on this foundation

1. Improved heat dissipation by removing the walls on both sides for air circulation. The honeycomb structure is also designed for better heat dissipation, but in reality, the honeycomb structure cannot function well. You can remove the honeycomb structure in the STP file.

2. On top of the base, I designed a groove to place the three pack voucher and the beginner's guide, which can prevent them from being lost.

3. I designed two drawers, one at the front and the other at the back.

4. I think the official tool storage box is perfect, so I tend to keep the official box and place it in the front drawer.

5. I really like the official glue and have also placed it in the front drawer.

6. The back drawer is designed according to the printing size of A1mini, and you can make modifications in the STP file to expand it.

7. I designed magnets to adsorb the construction board, front drawer, back drawer, and side garbage box, but the effect was not very good. You can modify it in the STP file, and it can still function normally without placing magnets.

8. If too much lubricating oil is added to the Z-axis, it will flow out through the lower part of the machine. Please note this, it is very important!!!

9. To prevent displacement, it is necessary to add a 20mm diameter and 5mm high soft pad at the bottom.