This is a wallmount I designed to hang up a Mould King 13126 AMG GTR on the wall.

I was using the Plexiglass pannels I already had at home, in the size of 70cm (height) x 40cm (width) x 5mm (depth). The hole in the Plexiglass to fit the wallmount is 8mm. The location of the hole differs for each car model.

In the wall there was already a dowel for the screw.

With this model you also need another hole in the pannel as a counter part to hold the mount itself. This is due to the weight of the car and the point where it attaches. Best way is to print the mount and meassure out where you want the pannel or the car to sit later on. After that you just use the holes in the mount to see where you need to drill. The counter screw on top needs to be very low or you just cut it up so that it fits with the mount. I then used a nut to keep the mount to the pannel as it was pushing off before because of the weight and the pin point. 
 

I purchased colored adhesive film on Amazon and attached it onto the back of the pannel for a shiny finish. You can also attach the film to the front of the pannel instead, for a matte finish.

You can screw the wallmount directly through the hole in the Plexiglass pannel in the wall. There is no option to attach the mount to the wall without the plexiglass as you need the counter screw to hold it together.

To attach the car to the wallmount, you need one brick Technic pin.

THE OTHER HOLES YOU CAN SEE IN THE PANNEL WERE DRILLED FOR ANTOHER PROJECT AND ARE NOT NECESSARY FOR THIS BUILD